To set up remote debugging for native COBOL applications

Restriction: The following applies to native code only.

Before you start Enterprise Developer, ensure that the local and remote systems are networked using TCP/IP.
On the remote machine, start an Enterprise Developer command prompt. If you need instructions, see To start an Enterprise Developer command prompt.
Start a cobdebugremote process by entering:
```
cobdebugremote port=nnnnn
```
where nnnn is the port number. We recommend that you use a port number greater than 1024 as numbers below are for system use.
Notes:
- By default, the cobdebugremote process exits after the debug session has completed. To keep the process running and listening for another connection, start the process with the repeat option:
```
cobdebugremote port=nnnnn repeat
```
- If you need to debug a 64-bit application, start cobdebugremote64 in the same way. For 64-bit-only remote products, this is the only available command.
On both the remote and local machines, do one of the following:
- Configure the firewall so it allows the Micro Focus Debugger Proxy V2.
- Open a TCP port for communications in the firewall. The port number you add should be the one you specified on the cobdebugremote or cobdebugremote64 command line.