Exception Messages for 5250 Printing
If you are running a 5250 printer emulation code, you may see an exception code display in the printer panel Status box. Refer to the following table for more information.
| Code | Meaning |
|---|---|
| 10 | The data stream control is unsupported or unrecognized. |
| 11 | Printing will occur outside the specified left or right margin. |
| 12 | An illegal superscript or subscript character was received. |
| 13 | The data stream control is not supported unless the Bypass Windows print driver in transparent mode check box is selected. |
| 14 | A graphics character is unprintable. |
| 15 | The data stream control is not supported while the Bypass Windows print driver in transparent mode check box is selected. |
| 16 | Printing will occur above or below the specified top or bottom margin. |
| 17 | A control in the data stream is illegally nested. |
| 20 | A supported control exists at an invalid position in the data stream. |
| 21 | An invalid indent level was received or there is no tab stop at the specified indent level. |
| 22 | No horizontal tab stop setting found. |
| 23 | The length of a line exceeds the justified right margin or the margin exceeds the page width. |
| 24 | Backspacing will occur beyond the leftmost physical print position. |
| 25 | Text will be printed below the bottom of the page. |
| 26 | Justify control violation. |
| 30 | Unsupported data stream control. |
| 31 | A required control parameter is missing. |
| 32 | An unsupported control parameter has been detected. |
| 40 | Invalid parameter value in multi-byte control. |
More information